Creo 2.0 SheetMetal design

Partner: Udemy
Affiliate Name:
Area:
Description: In this course, you will learnThe sheet metal design processSheetmetal model creation, conversion, and displayMethods of developed length calculationPrimary wall featuresSecondary wall featuresPartial wallsBend reliefUnbend and bend back featuresSheetmetal bend featuresFlat patternsSheetmetal cutsFormsNotch and punch featuresSheetmetal environment setupSheetmetal design Information toolsSheetmetal design rulesDetailing sheetmetal designsTopics Covered: 1: Introduction to the Creo Parametric Sheetmetal Design Process 2: Sheetmetal Model Fundamentals 3: Creating Primary Sheetmetal Wall Features 4: Creating Secondary Sheetmetal Wall Features 5: Bending and Unbending Sheetmetal Models 6: Modifying Sheetmetal Models 7: Sheetmetal Setup and Tools 8: Detailing Sheetmetal DesignsAbout Sheetmetal Design PropertiesSheet metal properties and their associated settings can be used to predefine common feature geometry, automate tasks, and maintain design consistency for sheet metal parts. The values of these settings depend on any predefined sheet metal parameters. The following properties specific to sheet metal are available in the Sheetmetal section of the Model Properties dialogue box:• Bend Allowance—Displays the factor type for bend allowance calculations and whether a bend table is assigned to the model.• Bends—Displays the radius size and the location for dimensioning bends.• Relief—Displays the type of bend and corner relief.• Edge Treatment—Displays the type of edge treatment.• Miter Cuts—Displays the
Category: Design > Design Tools > Sheet Metal
Partner ID:
Price: 19.99
Commission:
Source: Impact
Go to Course